Honda Civic Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
this is were it all started[attachment=6:d7d3d18z]pic1.jpg[/attachment:d7d3d18z]
then came the lights i got em cheap there a one of projector lights and i got a 8000k HID kit for them and a ek9 type r drille and decided to leave it black
took the badges of from hte back [attachment=5:d7d3d18z]pic pompy.jpg[/attachment:d7d3d18z]

a short ram induction kit and an exedy racing clutch just gone in for now aswell,
here are the alloys being prepared[attachment=4:d7d3d18z]alloyrub.jpg[/attachment:d7d3d18z]
here they are being sprayed[attachment=3:d7d3d18z]alloys spraying.jpg[/attachment:d7d3d18z]

then i gave them a little spice hehe :idea:[attachment=2:d7d3d18z]alloys spryed.jpg[/attachment:d7d3d18z]

[attachment=0:d7d3d18z]piclow.jpg[/attachment:d7d3d18z]

then i got the ek9 type r suspension put in and the small number plate made[attachment=1:d7d3d18z]picnew.jpg[/attachment:d7d3d18z] i now need to get the rear ek9 lip and just send it in for a spray then it will be compleate from the outside then the 160 bhp DOHC engine needs attention.any suggestions anybody?
 

Attachments

·
Registered
Joined
·
4,092 Posts
For the engine you have a few options:

Swap it for a B18
Build a B20 VTEC
Go for a head skim and beathing mods on the B16
Turbo it :twisted:
 

·
Registered
Joined
·
50 Posts
Discussion Starter #6
its sold now but when i was done with it it looked nice after those mods I put a seat leon cupra r lip on the front with m3 bumper struts and a rear type r lip and to finish a supra exhaut coming out at an angle with a de cat and the number plate holes flushed.

i got 3750 for it cost me 2800 all done



 
1 - 8 of 8 Posts
Top